420886725 Armature Stator Coil for Sea-Doo SPX 650 1995

Armature/Stator Coil for Sea-Doo SPX 650

This armature/stator coil is a replacement electrical component for the Sea-Doo SPX 650 1995, cross-referenced to OEM part number 420886725, and it supplies the ignition and charging current that keeps the engine running.

Overview

This armature/stator coil is a direct-fit replacement electrical part for the Sea-Doo SPX 650 1995 personal watercraft. The armature/stator coil sits inside the magneto and generates the electrical current for the ignition and charging systems, so a worn unit leaves you with no spark or a dead battery.

Built For Performance

• Wound and assembled to match the OEM 420886725 electrical specification
• Produces ignition and charging current for the 650 engine platform
• Direct replacement for a failed or weak factory stator
• Sealed construction suited to the damp, high-vibration PWC environment
• Installs on the factory stator plate mounting points

Fits These Machines

• for Sea-Doo SPX 650, 1995

On-The-Job Use

• Restoring spark to a no-start or hard-start Sea-Doo SPX 650
• Replacing a stator that has stopped charging the battery on the water
• Routine ignition system service on a 1995 SPX 650
• Rebuilding the magneto side of the engine during a top-end refresh

Specs At A Glance

Good To Know

Q: How do I know my stator coil has failed? A: Loss of spark, a battery that will not stay charged, or erratic running are the usual signs on a Sea-Doo SPX 650. Testing the coil resistance against the factory spec confirms it before you order.

Q: Does this replace the factory part directly? A: It is built to match OEM 420886725 and mounts to the original stator plate location. Reuse the factory fasteners and check the air gap during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.