420886725 Armature Stator Coil for Sea-Doo XP 650 1995

Armature/Stator Coil for Sea-Doo

This armature/stator coil is a replacement charging component that restores electrical output on the listed watercraft; it cross-references OEM part number 420886725.

Overview

This armature/stator coil provides the electrical current that charges the battery and powers the ignition on the listed Sea-Doo watercraft. The stator coil mounts in the flywheel housing and delivers steady output so the engine starts and runs reliably. It is intended for riders replacing a failed stator on a Sea-Doo XP 650.

Built For Performance

• Wound to match the OEM 420886725 electrical specification
• Delivers stable charging output for the battery and ignition
• Direct bolt-in fit to the factory stator mounting location
• Insulated windings resist heat and moisture in the engine bay
• Connector matches the factory wiring harness for simple installation

Fits These Machines

• for Sea-Doo XP 650
• for Sea-Doo 650-powered models listed above

On-The-Job Use

• Restoring charging output on a watercraft with a weak or failed stator
• Replacing a burnt or shorted stator during engine service
• Keeping the battery charged during long rides and repeated starts
• Getting a stalled machine back on the water after an electrical failure

Specs At A Glance

Good To Know

Q: Will this stator coil fit my 1995 Sea-Doo XP 650? A: It is built to fit the XP 650 with the 650 engine as listed, so confirm your model and engine before ordering. Q: Do I need to replace the regulator when installing a new stator? A: Not always, but a failed regulator can damage a new stator, so it is wise to test the charging system before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.