420889726 Armature Stator Coil for Sea-Doo Challenger Wake 310 1503 2008

Armature/Stator Coil for Sea-Doo

This armature and stator coil assembly keeps your jet boat engine charging, cross-referenced to OEM part number 420889726.

Overview

This armature and stator coil is a charging-system replacement for your watercraft engine. As the flywheel turns, the stator produces AC current that the regulator converts to charge your battery and run the ignition. It is aimed at owners of the 1503-equipped Challenger Wake who need to restore charging output.

Built For Performance

• Cross-referenced to OEM part number 420889726 for easy matching
• Windings built for steady AC output through the RPM range
• Insulated construction handles heat and moisture in the engine bay
• Direct replacement for a failed or weak charging coil
• Made to hold up to the vibration of a 1503 four-stroke engine

Fits These Machines

• for Sea-Doo Challenger Wake 310, 2008, 1503 engine
• for Sea-Doo Challenger Wake 430, 2008, 1503 engine

On-The-Job Use

• Bringing charging output back on a 2008 Challenger Wake
• Replacing a burned or open-circuited stator after a charging fault
• Electrical service while the flywheel cover is open
• Fixing a weak-battery or no-start condition on the water

Specs At A Glance

Good To Know

Q: Does this match my 2008 Challenger Wake 310? A: It is listed for the 1503 engine in that model and year. Verify by serial number or engine code before ordering.

Q: Should I replace anything else at the same time? A: A new cover gasket or seal is often needed. Check the regulator and flywheel while you have access.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.