420911552 Power Valve Regulator Cover for Sea-Doo XP 800 1995-1997

Power Valve Regulator Cover for Sea-Doo

This power valve regulator cover fits Sea-Doo XP 800 models from 1995 to 1997 and carries OEM cross-reference 420911552, giving the RAVE exhaust valve assembly a secure housing that keeps its regulator diaphragm and spring properly contained.

Overview

This power valve regulator cover is a direct-fit housing for the RAVE exhaust power valve system on Sea-Doo XP 800 watercraft. The power valve regulator cover holds the valve diaphragm and spring in place so the exhaust port timing can open and close as RPM climbs. It suits riders maintaining a 1995 to 1997 Sea-Doo XP 800 who need a replacement cover that matches the original mounting points.

Built For Performance

• Direct replacement for OEM part number 420911552
• Houses the RAVE power valve diaphragm and spring
• Mounting pattern matches the original regulator body
• Seals the valve assembly against exhaust gases and water spray
• Constructed from corrosion-resistant material for marine use

Fits These Machines

• for Sea-Doo XP 800 (1995-1997)

On-The-Job Use

• Rebuilding a RAVE exhaust valve assembly
• Restoring factory power valve operation after a cover crack
• Routine top-end maintenance on an 800 engine
• Replacing a stripped or leaking regulator cover

Specs At A Glance

Good To Know

Q: Is this cover a genuine Sea-Doo part? A: No, it is an aftermarket regulator cover built to match OEM part number 420911552. Confirm your engine uses that number before ordering.

Q: Does the cover include the diaphragm and spring? A: This listing covers the regulator cover only, so inspect your existing diaphragm and spring and replace them separately if worn.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.