420917515 Connecting Rod Kit for Sea-Doo GTI STD 1503 2006 2019

Connecting Rod Kit for Sea-Doo GTI STD 1503

This connecting rod kit gives Sea-Doo GTI STD 1503 owners a complete lower-end rebuild component for the 1503 engine, restoring proper crank geometry so the rotating assembly can return to factory-spec operation after rod wear or failure.

Overview

This connecting rod kit is a direct replacement component for the Sea-Doo GTI STD 1503 engine, built to bring a damaged crank assembly back to spec. It serves riders and rebuilders working on 2006 and 2019 model years and fits the standard 1503 powerplant. Each kit is produced to OEM-equivalent tolerances so installation matches the Sea-Doo GTI STD 1503 platform without modification.

Built For Performance

• Manufactured to OEM-equivalent dimensions for the 1503 engine
• Forged steel construction rated for high-load crank duty
• Balanced weight distribution to minimize vibration at high RPM
• Machined bearing surfaces for consistent oil film control
• Complete kit with rod, bearing, and pin for full assembly replacement

Fits These Machines

• for Sea-Doo GTI STD 1503 (2006)
• for Sea-Doo GTI STD 1503 (2019)

On-The-Job Use

• Bottom-end rebuilds after rod bearing failure
• Crankcase service on 1503-equipped personal watercraft
• Preventive replacement during full engine overhauls
• Repair work following water ingestion or oil starvation

Specs At A Glance

Good To Know

Q: Does this kit include everything needed for one rod replacement? A: Yes, the kit ships with the rod, bearing, and pin so a single assembly can be replaced without sourcing extra parts. Q: Can this kit be used on both 2006 and 2019 model years? A: Yes, the kit is listed for both model years and the standard 1503 engine platform, but serial number verification is advised before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.