420931130 Timing Drive Cover Gasket for Sea-Doo GTI Rental 1503 2006-2010

Timing Drive Cover Gasket for Sea-Doo

This timing drive cover gasket for Sea-Doo seals the timing drive cover to the engine block, keeping oil contained and contaminants out of the timing drive area; it references OEM part number 420931130.

Overview

This timing drive cover gasket is a direct-fit sealing component for the timing drive cover on select Sea-Doo personal watercraft. The gasket for Sea-Doo keeps engine oil where it belongs while blocking water and debris from reaching the timing drive cavity. It is intended for riders and mechanics replacing a worn, weeping, or failed gasket during routine engine service.

Built For Performance

• Precision-cut to match the timing drive cover mating surface
• Constructed from oil-resistant gasket material for long service life
• Seals against oil seepage under normal operating temperatures
• Replaces OEM part number 420931130 for a direct fit
• Resists compression set to maintain a consistent seal

Fits These Machines

• for Sea-Doo GTI Rental 1503 (2006-2010)

On-The-Job Use

• Routine timing drive cover resealing during engine maintenance
• Repairing oil leaks traced to the timing drive cover area
• Top-end or timing component service on 1503 engines
• Preventive replacement during a full engine inspection

Specs At A Glance

Good To Know

Q: Does this gasket require sealant during installation? A: Most installations call for a clean, dry mating surface and no additional sealant, though some technicians apply a thin bead at specific corners. Follow the service manual for your model.

Q: Can this gasket be reused if the cover is removed again? A: A gasket that has already been compressed should be replaced rather than reused. A fresh gasket for Sea-Doo ensures a reliable seal the next time the cover goes back on.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.