420931130 Timing Drive Cover Gasket for Sea-Doo Speedster Wake 430 1503 2008

Timing Drive Cover Gasket for Sea-Doo

This timing drive cover gasket seals the timing drive cover on 1503 engine platforms, replacing OEM reference 420931130 to keep oil contained and the timing drive protected.

Overview

This timing drive cover gasket is a sealing component made to fit the 1503 engine used in the Sea-Doo Speedster Wake 430. The timing drive cover gasket sits between the cover and the engine case, preventing oil seepage and keeping the timing drive free of contaminants. It suits owners doing routine maintenance or rebuilding a timing drive cover gasket on a 1503 powered boat.

Built For Performance

• Direct replacement for OEM reference 420931130
• Precision cut to match the timing drive cover mating surface
• Oil resistant material suited to continuous engine heat cycles
• Seals the timing drive cavity against oil weep and spray
• Flexible enough to compress evenly under cover torque

Fits These Machines

• for Sea-Doo Speedster Wake 430 1503, 2008

On-The-Job Use

• Timing drive cover service on 1503 engine platforms
• Routine resealing during top end or cover work
• Rebuilds where the original gasket is crushed or leaking
• Seasonal maintenance before extended boating periods

Specs At A Glance

Good To Know

Q: Does this gasket need sealant during installation? A: Most timing drive cover gaskets install dry on a clean, flat surface, but always follow the service procedure for your model. Inspect the cover and case for scratches or nicks before torquing it down.

Q: Can I reuse the original gasket instead of replacing it? A: A gasket that has been compressed or exposed to heat should be replaced once the cover is removed. Reusing it risks oil leakage and repeat teardown.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.