420950792 Throttle Body Gasket for Sea-Doo GTI SE 130 1630 2020-2026

Throttle Body Gasket for Sea-Doo GTI SE 130

This throttle body gasket is designed to seal the connection between the throttle body and intake on 1630 engine Sea-Doo GTI SE 130 watercraft, referencing OEM part number 420950792.

Overview

The throttle body gasket for Sea-Doo GTI SE 130 provides a tight, reliable seal at the throttle body mounting point to keep air and fuel delivery consistent. Crafted to match the OEM 420950792 fit, this gasket helps prevent vacuum leaks that can cause rough idling or hesitation. It is a direct-fit replacement for riders maintaining their 1630 engine Sea-Doo GTI SE 130.

Built For Performance

• Seals the throttle body to intake manifold mating surface
• Prevents vacuum leaks that affect idle and throttle response
• Constructed from fuel and heat resistant composite material
• Precision cut to match OEM 420950792 port geometry
• Withstands repeated engine heat cycles on the water

Fits These Machines

• for Sea-Doo GTI SE 130 1630, 2020-2026

On-The-Job Use

• Replacing a worn or leaking gasket during throttle body service
• Intake maintenance on 1630 engine Sea-Doo GTI SE 130 models
• Restoring smooth idle and consistent throttle input
• Routine top-end reassembly after cleaning or inspection

Specs At A Glance

Good To Know

Q: Does this gasket require sealant during installation? A: No, this gasket is designed to seal on its own without gasket sealer. Install it dry on a clean, flat mating surface.

Q: Can I reuse this gasket after removal? A: Gaskets are typically single-use and should be replaced once removed. A fresh gasket ensures a proper seal and avoids vacuum leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.