420x90 Drive Chain for Kawasaki KLX110, KLX110L, KLX110R & KLX110R L 2010-2025

420x90 Drive Chain for Kawasaki

This 420x90 drive chain for Kawasaki transfers power from the transmission output shaft to the rear wheel sprocket for consistent acceleration.

Overview

The 420x90 drive chain for Kawasaki provides the necessary tensile strength to handle power delivery in various off-road environments. This 420x90 drive chain for Kawasaki is engineered for durability and longevity under heavy torque loads. It is a fundamental replacement part for enthusiasts keeping their machines maintained for daily riding.

Built For Performance

• Pre-stretched to minimize initial chain sag
• Solid rollers for reduced friction and heat
• Reinforced side plates for increased tensile strength
• Wear-resistant alloy pin material

Fits These Machines

• for Kawasaki KLX110
• for Kawasaki KLX110L
• for Kawasaki KLX110R
• for Kawasaki KLX110R L

On-The-Job Use

• Maintaining smooth power transfer during off-road riding
• Replacing stretched or seized factory chains
• Restoring original performance to the drivetrain

Specs At A Glance

Good To Know

Q: Should I replace the sprockets with the chain? A: Replacing the sprockets along with the chain is recommended to prevent premature wear on the new components. A: Always check that your sprocket teeth are not hooked or worn before installing a new chain.

Q: How do I maintain this chain? A: Clean and lubricate the chain regularly using a motorcycle-specific chain wax to ensure maximum lifespan. A: Proper tension adjustment is vital to avoid unnecessary strain on the countershaft seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.