428-128 O-Ring Drive Chain for Yamaha XT250 2008-2024
428-128 O-Ring Drive Chain for Yamaha XT250 2008-2024
Couldn't load pickup availability
Drive Chain for Yamaha XT250
This 428-128 O-ring drive chain is a direct replacement component for the Yamaha XT250, delivering reliable power transfer from the countershaft sprocket to the rear wheel.
Overview
This 428-128 O-ring drive chain is built to replace the worn or stretched chain on a Yamaha XT250. The O-ring design seals lubricant inside each roller, which reduces friction and extends the service life of the drive chain. Riders who put steady miles on their XT250 will find this chain a practical wear item to keep on hand.
Built For Performance
- O-ring sealed construction retains grease inside each roller for longer wear life
- 128-link count fits the stock XT250 chain length without trimming in most cases
- 428 pitch matches the OEM sprocket sizing on the XT250
- Pre-stretched during manufacturing to reduce initial elongation after installation
- Roller design resists grit and moisture intrusion on dusty or wet rides
Fits These Machines
- for Yamaha XT250 2008
- for Yamaha XT250 2009
- for Yamaha XT250 2010
- for Yamaha XT250 2011
- for Yamaha XT250 2012
- for Yamaha XT250 2013
- for Yamaha XT250 2014
- for Yamaha XT250 2015
- for Yamaha XT250 2016
- for Yamaha XT250 2017
- for Yamaha XT250 2018
- for Yamaha XT250 2019
- for Yamaha XT250 2020
- for Yamaha XT250 2021
- for Yamaha XT250 2022
- for Yamaha XT250 2023
- for Yamaha XT250 2024
On-The-Job Use
- Routine drivetrain maintenance on dual-sport and trail rides
- Replacing a stretched or kinked chain before it damages sprockets
- Commuting and light off-road use where chain longevity matters
- Scheduled service intervals when both sprockets are still within spec
Specs At A Glance
| Chain Type | O-ring sealed |
| Pitch | 428 |
| Link Count | 128 |
| Fitment | for Yamaha XT250 2008-2024 |
Good To Know
Q: Do I need to shorten this chain for my XT250? A: The 128-link count is sized for the stock XT250 setup, so trimming is usually unnecessary unless your sprocket sizes have been changed. Always check chain slack after installation.
Q: How often should an O-ring chain be lubricated? A: Even sealed chains benefit from regular cleaning and light lubrication, especially after wet or dusty rides. Inspect for tight links and adjust slack at the intervals listed in your owner's manual.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
