47013002000 Brake Lever for KTM XC 65 2008-2009 XC65

Brake Lever for KTM XC 65

This brake lever is a replacement control component for the KTM XC 65, cross-referenced to OEM part number 47013002000, and it restores reliable front or rear brake actuation on your minicycle.

Overview

This brake lever for KTM XC 65 gives riders a direct replacement for a worn or bent lever on the 2008-2009 XC65. It is built to match the factory mounting points and pivot geometry so the lever bolts on and engages the brake system the way the original did. A solid brake lever for KTM XC 65 is a straightforward way to keep braking response consistent on the track or trail.

Built For Performance

• Cross-referenced to OEM part number 47013002000 for straightforward identification
• Durable construction suited to the demands of off-road riding
• Lever profile shaped for a secure, controlled pull
• Mounting dimensions matched to the XC 65 brake perch
• Direct replacement design that installs without modification

Fits These Machines

• for KTM XC 65 2008
• for KTM XC 65 2009

On-The-Job Use

• Motocross and off-road practice sessions
• Trail riding where brake control matters on descents
• Race day spares and trackside repairs
• Rebuilding a used XC 65 for resale or personal use

Specs At A Glance

Good To Know

Q: Will this lever fit both sides of the bike? A: This lever is intended for the brake side application listed for the XC 65. Confirm which side you need before ordering, since clutch levers use a different part.

Q: Do I need any extra hardware to install it? A: The lever typically mounts using the existing perch and pivot hardware from your bike. Reusing the original bolt and spring is common, so check your current setup first.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.