503191183 Suspension Spring Retainer for Ski-Doo Tundra 300 2008-2009

Suspension Spring Retainer for Ski-Doo

This suspension spring retainer secures the spring on your snowmobile's suspension and references OEM part number 503191183.

Overview

The suspension spring retainer is a direct-fit replacement that holds the suspension spring firmly in place on your sled. This spring retainer keeps the spring seated correctly so the rear suspension can soak up bumps as designed. Designed for riders servicing or restoring the suspension on Ski-Doo Tundra 300 snowmobiles from 2008 through 2009.

Built For Performance

• References OEM part number 503191183 for straightforward cross-checking
• Retains the suspension spring in its proper seated position
• Helps maintain consistent spring tension through suspension travel
• Built to handle the loads and vibration of trail and utility riding
• Direct replacement for worn or missing retainers

Fits These Machines

• for Ski-Doo Tundra 300 (2008-2009)

On-The-Job Use

• Suspension rebuilds and seasonal maintenance
• Restoring a sled with missing or damaged spring hardware
• Trail and utility riding in cold climates
• Shop repair work and DIY servicing

Specs At A Glance

Good To Know

Q: Does this retainer fit both sides of the suspension? A: This retainer is designed to fit the suspension spring location shown for this model, so check your service diagram to confirm how many your sled uses. Q: Do I need any special tools to install it? A: Basic hand tools are typically enough, but having the spring load relieved before you remove or seat the retainer makes the job safer and easier.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.