Skip to product information
1 of 2

508-0005-73 Intake Boot for Ski-Doo Summit Everest 800R E-Tec 2011

508-0005-73 Intake Boot for Ski-Doo Summit Everest 800R E-Tec 2011

Regular price $32.99
Regular price Sale price $32.99
Sale Sold out
Quantity

Intake Boot for Ski-Doo

This intake boot replaces OEM part 508-0005-73 on Ski-Doo Summit Everest 800R E-Tec snowmobiles, sealing the air path between the throttle body and engine intake.

Overview

The intake boot for Ski-Doo is a direct-fit rubber connector that joins the throttle body to the engine intake on 800R E-Tec sleds. It keeps the air charge sealed so the engine pulls clean, metered air instead of drawing unfiltered air through a cracked or hardened boot. Riders and mechanics chasing lean conditions, rough idle, or a check engine light on a Summit Everest often trace the fault to this intake boot.

Built For Performance

  • Molded rubber construction resists the heat and vibration of two-stroke snowmobile service
  • Direct replacement for OEM part number 508-0005-73
  • Seals the throttle body to intake joint to prevent unmetered air leaks
  • Flexible wall allows for engine movement without cracking at the clamps
  • Retains factory mounting points for a bolt-on installation

Fits These Machines

  • for Ski-Doo Summit Everest 800R E-Tec, 2011

On-The-Job Use

  • Replacing a cracked or heat-hardened intake boot during engine service
  • Restoring proper air metering on 800R E-Tec engines
  • Routine maintenance before or during a mountain riding season
  • Shop repairs on Summit Everest chassis

Specs At A Glance

Part Number(s) 508-0005-73
Component Intake Boot
Engine 800R E-Tec
Fitment Ski-Doo Summit Everest 2011

Good To Know

Q: How do I know if the intake boot needs replacing? A: Cracks, hardening, or a loose fit at the clamps are the usual signs, along with lean running symptoms on an 800R E-Tec. Inspect the boot closely since small tears can open up under vibration.

Q: Does this boot include clamps? A: Check the listing contents before ordering, as clamps are often sold separately. Reusing the original clamps is fine if they are in good condition.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details