512-0592-66 Choke Cable for Ski-Doo GTX LTD 800 HO PTEK 2007
512-0592-66 Choke Cable for Ski-Doo GTX LTD 800 HO PTEK 2007
Couldn't load pickup availability
Choke Cable for Ski-Doo GTX LTD 800 HO PTEK
This choke cable assembly is a direct replacement for the 2007 Ski-Doo GTX LTD 800 HO PTEK, letting you control the carburetor cold-start enrichment circuit from the handlebars. It carries the OEM cross-reference 512-0592-66 so you can match it against the part you are removing.
Overview
This choke cable for Ski-Doo GTX LTD 800 HO PTEK restores reliable cold-start fuel enrichment on your snowmobile. The choke cable routes from the handlebar lever to the carburetor, giving you full control over the starter circuit in cold conditions. It is built for riders replacing a stretched, sticky, or broken cable on the 2007 GTX LTD 800 HO PTEK.
Built For Performance
- OEM cross-reference 512-0592-66 for a direct fit on the listed application
- Inner cable designed for smooth, low-friction travel through the housing
- Protective outer sheath resists engine heat, moisture, and trail debris
- Pre-formed ends match the handlebar lever and carburetor connections
- Flexible housing rated for repeated seasonal cold-weather use
Fits These Machines
- for Ski-Doo GTX LTD 800 HO PTEK, 2007
On-The-Job Use
- Cold-starting and warm-up fuel enrichment on the trail or in the driveway
- Restoring proper choke lever travel on high-mileage snowmobiles
- Replacing a frayed or seized cable during seasonal maintenance
- Keeping the enrichment circuit reliable for early-season and deep-winter rides
Specs At A Glance
| Part Number(s) | 512-0592-66 |
| Type | Choke cable assembly |
| Application | Handlebar choke lever to carburetor |
| Compatible Model | Ski-Doo GTX LTD 800 HO PTEK, 2007 |
Good To Know
Q: How do I know this choke cable fits my sled? A: Match the 512-0592-66 part number to the cable you are replacing and confirm the model year of your GTX LTD 800 HO PTEK before ordering. Fit can vary by serial number, so verify against your machine.
Q: Can I install this choke cable myself? A: Yes, it is a serviceable wear item that routes from the handlebar lever to the carburetor and can be replaced with basic hand tools. Check cable routing and free play after installation so the lever engages and releases cleanly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
