512-0592-66 Choke Cable for Ski-Doo MXZ X-RS 800 HO PTEK 2007 MXZ X

Choke Cable for Ski-Doo MXZ X-RS 800 HO PTEK

This choke cable routes from the handlebar lever to the carburetor to deliver manual cold-start enrichment on the 2007 Ski-Doo MXZ X-RS 800 HO PTEK, carrying the 512-0592-66 reference number.

Overview

This choke cable is a direct-fit replacement for the 2007 Ski-Doo MXZ X-RS 800 HO PTEK snowmobile, giving the rider manual control of cold-start fuel enrichment from the handlebar. Built to match the original routing and lever pull, it restores dependable starting when the engine is cold. It suits riders maintaining or restoring a 2007 MXZ X-RS 800 HO PTEK.

Built For Performance

• Flexible inner cable sized for the 2007 MXZ X-RS 800 HO PTEK handlebar and carburetor routing
• Protective outer sheath resists moisture and abrasion from snow and trail debris
• Pre-formed end fittings match the choke lever and carburetor plunger connections
• Constructed for consistent pull and smooth operation in cold-weather conditions
• Carries the 512-0592-66 reference for straightforward parts lookup

Fits These Machines

• for Ski-Doo MXZ X-RS 800 HO PTEK (2007)

On-The-Job Use

• Cold starting on the trail or in the staging area
• Routine choke cable replacement during seasonal maintenance
• Restoring a 2007 MXZ X-RS 800 HO PTEK sled
• Carburetor tuning and cold-start enrichment service

Specs At A Glance

Good To Know

Q: How is the choke cable connected? A: It links the handlebar choke lever to the carburetor, allowing manual cold-start enrichment. Route it the same way as the original cable and adjust for smooth lever travel.

Q: Should the choke cable be checked during fueling? A: Verify the cable housing, ends, and lever pull are intact and the choke fully closes when released for correct cold-start operation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.