512-0604-11 Throttle Cable for Ski-Doo Renegade SP 800R PTEK 2011

Throttle Cable for Ski-Doo Renegade SP 800R PTEK

This throttle cable is a direct replacement for the Ski-Doo Renegade SP 800R PTEK, cross-referenced under part number 512-0604-11 and sized for 800cc engines, delivering smooth throttle response from handlebar to carburetor.

Overview

This throttle cable keeps the connection between your thumb lever and engine intact for the Ski-Doo Renegade SP 800R PTEK. It is built to restore crisp, reliable throttle actuation on 2011 800R PTEK sleds. Riders and mechanics replacing a frayed or sticky cable will find this throttle cable a straightforward swap.

Built For Performance

• Constructed with a flexible inner cable that slides freely through the outer housing
• Outer sheath resists abrasion, moisture, and cold-weather cracking
• Pre-formed ends match the throttle lever and carburetor fittings
• Correct length for the 800R PTEK chassis routing
• Cross-references part number 512-0604-11

Fits These Machines

• for Ski-Doo Renegade SP 800R PTEK, 2011

On-The-Job Use

• Trail riding where consistent throttle control matters
• Replacing a cable that has stretched, frayed, or seized
• Routine maintenance before the riding season
• Field repairs after cable damage from branches or ice

Specs At A Glance

Good To Know

Q: Will this cable fit my sled out of the box? A: It is built to the 512-0604-11 specification for the 2011 Renegade SP 800R PTEK, but routing and lever hardware should be checked before installation. Q: Do I need to adjust the cable after installing it? A: Yes, throttle free play should be set to the manufacturer's specification after routing the new cable.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.