520-112 O-Ring Drive Chain for Suzuki DR200 1986-1989 DR 200 Motorcycle

520-112 O-Ring Drive Chain for Suzuki DR200

This 520-112 O-Ring Drive Chain is a direct replacement drive chain that transfers engine power to the rear wheel on Suzuki DR200 models from 1986 to 1989.

Overview

The 520-112 O-Ring Drive Chain is a replacement drive chain built to keep power flowing smoothly from the countershaft sprocket to the rear wheel on Suzuki DR200 machines. This 520-112 O-Ring Drive Chain suits riders and mechanics maintaining 1986 through 1989 DR 200 models. O-ring seals hold lubricant in and keep grit out so the chain runs clean over the long haul.

Built For Performance

• O-ring construction seals grease at each pin and bushing joint to reduce wear
• 520 pitch sizing matches the DR200 countershaft and rear sprockets
• 112 links cover stock gearing without cutting on 1986 to 1989 DR 200 models
• Roller design spreads load evenly across the sprocket teeth
• Heat-treated pins resist stretching under sustained trail torque

Fits These Machines

• for Suzuki DR200 1986
• for Suzuki DR200 1987
• for Suzuki DR200 1988
• for Suzuki DR200 1989

On-The-Job Use

• Trail riding on dirt and fire roads where chain durability matters
• Commuting on older DR200 dual-sport machines
• Routine driveline service and chain replacement
• Restoring 1986 to 1989 DR 200 models that need fresh drive hardware

Specs At A Glance

Good To Know

Q: Is this chain an original Suzuki part? A: No, this is an aftermarket replacement chain made to fit Suzuki DR200 models. It is not manufactured or sold by Suzuki.

Q: Should I replace the sprockets at the same time? A: Worn sprockets accelerate chain wear, so inspect both sprockets and replace them together with the chain if teeth show hooking or thinning.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.