530-104 O-Ring Drive Chain for Yamaha XJ550 Maxim 1981-1983 XJ 550

530-104 O-Ring Drive Chain for Yamaha XJ550 Maxim

The 530-104 O-Ring Drive Chain is a sealed motorcycle drive chain that transfers power from the countershaft sprocket to the rear wheel, built to deliver long service life on the Yamaha XJ550 Maxim.

Overview

This 530-104 O-Ring Drive Chain is a sealed replacement drive chain for the Yamaha XJ550 Maxim, made to keep lubrication in and grit out of the pin and bushing joints. Riders replacing a stretched or worn-out chain will find the 530-104 O-Ring Drive Chain restores smooth, quiet power delivery to the rear wheel. The 530-104 O-Ring Drive Chain fits models listed in the title applications.

Built For Performance

• O-ring seals hold factory grease at the pin and bushing joints while blocking water, dust, and road grit
• Stamped outer plates riveted to heat-treated pins for consistent tensile strength
• Bushed rollers sized to 530 chain standard for smooth sprocket engagement
• Pre-stretched and pre-lubricated so it installs with minimal initial adjustment
• Sealed construction reduces friction loss compared to a standard non-sealed chain
• Corrosion-resistant coating helps resist rust from rain and washdowns

Fits These Machines

• for Yamaha XJ550 Maxim, 1981
• for Yamaha XJ550 Maxim, 1982
• for Yamaha XJ550 Maxim, 1983
• for Yamaha XJ 550

On-The-Job Use

• Everyday street riding and commuting on the XJ550 Maxim
• Weekend touring where chain life and low maintenance matter
• Restoring a stored or neglected Maxim to riding condition
• Routine drivetrain refresh alongside sprocket replacement

Specs At A Glance

Good To Know

Q: Does an O-ring chain need regular lubrication? A: Yes, the O-rings seal grease inside the joints but the rollers and sprocket contact still need chain lube to control wear. Clean and lube it on the same schedule you would a standard chain.

Q: Can I run a 104-link 530 chain on a stock XJ550 Maxim? A: A 104-link 530 chain matches the stock length on this model in most cases, but confirm link count against your sprocket sizes and swingarm setup. Trim links only if your manual calls for a shorter chain.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.