530-112 O-Ring Drive Chain for Yamaha FZ700 1987 FZ 700 Motorcycle

530-112 O-Ring Drive Chain for Yamaha FZ700

This 530-112 O-Ring Drive Chain is a replacement drive chain built to transfer power from the countershaft sprocket to the rear wheel on a Yamaha FZ700, and it matches the 530-112 chain size called for by the machine.

Overview

This 530-112 O-Ring Drive Chain gives Yamaha FZ700 riders a direct replacement for a worn or stretched chain. The O-ring design holds lubricant at the pins to reduce friction and slow elongation, so the chain stays within adjustment longer. It suits riders doing routine driveline maintenance or a full chain and sprocket refresh on a 1987 FZ700.

Built For Performance

• O-ring seals at each pin retain factory grease and block grit and moisture
• 530 pitch sizing matches the FZ700 driveline without modification
• 112 link count suits the stock gearing and swingarm length of the FZ700
• Roller and pin construction built to handle street and highway power loads
• Pre-stretched during manufacturing to limit initial break-in adjustment

Fits These Machines

• for Yamaha FZ700 1987

On-The-Job Use

• Everyday street riding and commuting
• Highway cruising at sustained speed
• Weekend backroad rides
• Replacing a stretched or kinked chain during scheduled maintenance

Specs At A Glance

Good To Know

Q: Do I need a special tool to install this chain? A: Yes, a chain rivet or clip-style master link tool is normally required, and you should confirm which master link type your chain ships with before starting the job.

Q: Should I replace the sprockets at the same time? A: It is good practice to inspect both sprockets for hooked or worn teeth whenever a new chain goes on, since a worn sprocket will wear out a fresh chain quickly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.