532175572 Steering Drag Link Ball Joint For Husqvarna GTH250 GTH2548 GTH2550

Steering Drag Link Ball Joint for Husqvarna

This steering drag link ball joint (OEM 532175572) replaces worn drag link ends on Husqvarna GTH250, GTH2548, and GTH2550 lawn tractors.

Overview

The steering drag link ball joint is the pivot point that connects the steering drag link to the spindle, translating steering wheel input into wheel motion. This replacement ball joint eliminates slop in Husqvarna GTH250, GTH2548, and GTH2550 models, giving precise, predictable steering. Built to exacting tolerances, the drag link ball joint restores factory handling and reduces tire scrub.

Built For Performance

• Forged alloy steel body resists impact and fatigue
• Hardened and polished ball stud minimizes friction and wear
• Grease groove and zerk fitting simplify routine lubrication
• Neoprene boot seals out dirt, water, and debris
• Corrosion-resistant plating extends service life
• Precisely sized taper and thread for direct bolt‑on fit

Fits These Machines

• for Husqvarna GTH250
• for Husqvarna GTH2548
• for Husqvarna GTH2550

On-The-Job Use

• Steering linkage overhaul on garden tractors
• Replacing a seized or sloppy drag link ball joint
• Restoring steering accuracy after impact or rough terrain use
• Annual maintenance during front‑end service

Specs At A Glance

Good To Know

Q: How can I tell if my drag link ball joint is worn out? A: Symptoms include loose or wandering steering, a dead spot in the wheel, and clunking when turning. Inspect the joint for play and a torn boot.

Q: Do I need to grease this ball joint after installation? A: Yes, pump fresh grease through the zerk fitting until the boot just begins to swell, then wipe away excess to keep the joint lubricated and quiet.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.