536M07200 Wiseco Std Piston Kit for Polaris Cyclone Scrambler 250 1985-1988

Wiseco Std Piston Kit for Polaris Cyclone & Scrambler 250

This standard bore piston kit for Polaris Cyclone and Scrambler 250 machines is a 1985 to 1988 top-end rebuild component, cross-referenced to Wiseco part number 536M07200.

Overview

This Wiseco Std Piston Kit for Polaris Cyclone and Scrambler 250 models delivers a direct fit for worn or damaged top ends. Each kit is assembled for the 250 engine platform produced between 1985 and 1988. Riders and rebuilders choose this piston kit for Polaris Cyclone and Scrambler 250 restorations that call for dependable sealing and compression.

Built For Performance

• Standard bore sizing for stock cylinder dimensions
• Forged piston construction for strength under heat and load
• Ring set included for a complete top-end refresh
• Wrist pin and circlips supplied for assembly
• Machined to part number 536M07200 specifications

Fits These Machines

• for Polaris Cyclone 250, 1985-1988
• for Polaris Scrambler 250, 1985-1988

On-The-Job Use

• Top-end rebuilds after piston scoring or ring wear
• Restoration projects for 1980s Polaris 250 machines
• Trail and recreation riding on Cyclone and Scrambler models
• Routine maintenance when compression falls below spec

Specs At A Glance

Good To Know

Q: What does a standard bore piston kit include? A: A standard kit typically contains the piston, rings, wrist pin, and circlips needed for a top-end refresh. Confirm the contents against your engine's requirements before assembly.

Q: How do I know if standard bore is right for my cylinder? A: Standard bore suits cylinders that measure within factory specs and do not need overboring. Have the bore measured before ordering to avoid fit issues.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.