573M06600 Wiseco Std Piston Kit for Yamaha Blaster 200 1988-2006

Std Piston Kit for Yamaha Blaster 200

This Wiseco standard piston kit, referenced as 573M06600, is a top-end rebuild component for the Yamaha Blaster 200, restoring compression and piston-to-cylinder sealing.

Overview

This standard piston kit is made for the Yamaha Blaster 200 and covers the 1988 through 2006 model range. The kit supplies a standard-bore piston with the components needed for a fresh top end, replacing a scuffed, worn, or out-of-spec piston. It is intended for riders and rebuilders doing routine two-stroke top-end service.

Built For Performance

• Standard-bore piston spec for the Blaster 200 top end
• Wiseco forged piston construction for strength under two-stroke loads
• Includes piston, rings, wrist pin, and circlips where supplied in the kit
• Cross-reference number 573M06600 for build verification
• Designed for use with the stock cylinder bore size

Fits These Machines

• for Yamaha Blaster 200, 1988-2006

On-The-Job Use

• Top-end rebuild after a seizure or loss of compression
• Routine refresh during a two-stroke service interval
• Trail quad maintenance for continued recreational riding
• Restoring a tired Blaster 200 engine to stock bore spec

Specs At A Glance

Good To Know

Q: Does this piston kit require a bore check before installation? A: Yes, measure the cylinder bore and piston-to-wall clearance before fitting, because a worn or out-of-round cylinder needs machining rather than a drop-in standard piston.

Q: Should I replace other top-end parts at the same time? A: Compression issues often pair with worn bearings or a tired cylinder head, so inspecting the crank and replacing gaskets while the top end is apart is a sound practice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.