580 Connecting Rod Kit for Sea-Doo SP 1989-1996

Connecting Rod Kit for Sea-Doo SP 580

This connecting rod kit is a direct replacement component for the Sea-Doo SP 580, designed to restore the crankshaft assembly in 1989-1996 models.

Overview

This connecting rod kit for Sea-Doo SP 580 provides the rod, bearing, and related hardware needed to rebuild a worn crankshaft assembly. It is built to match the original dimensions for 580cc engines used across the 1989-1996 SP lineup. This connecting rod kit for Sea-Doo SP 580 is intended for riders and mechanics performing a top-to-bottom engine refresh.

Built For Performance

• Forged steel rod construction for strength under load
• Precision-machined big end and small end bores
• Includes caged needle bearing for the lower rod journal
• Balanced to match the 580cc crankshaft assembly
• Heat-treated surfaces for wear resistance
• Designed as a direct replacement for the original rod

Fits These Machines

• for Sea-Doo SP 580 (1989-1996)

On-The-Job Use

• Crankshaft rebuilds on 580cc Sea-Doo personal watercraft
• Top-end and bottom-end engine refresh projects
• Restoring compression and rod alignment after bearing failure
• Routine maintenance for older PWC engines

Specs At A Glance

Good To Know

Q: Does this kit include bearings and hardware? A: Yes, the kit includes the rod, lower bearing, and related hardware for a crankshaft rebuild. Always compare your old parts against the kit before assembly.

Q: Can I install this myself? A: Crankshaft assembly typically requires specialized tools and press equipment. Professional installation is recommended for proper alignment and balance.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.