5830013 Flame Arrestor Gasket for Polaris SL 750 1993-1995

Flame Arrestor Gasket for Polaris

This flame arrestor gasket seals the flame arrestor to the carburetor on Polaris SL 750 watercraft, replacing OEM part 5830013 to maintain a proper air-fuel seal.

Overview

This flame arrestor gasket is a replacement sealing component for the Polaris SL 750 produced from 1993 through 1995. It fits between the flame arrestor and carburetor, preventing air leaks that can cause lean running or hard starting. A simple part to keep on hand for carburetor service and routine maintenance.

Built For Performance

• Cut to match OEM 5830013 bolt pattern and bore size
• Fuel and heat resistant material suited to marine engine bays
• Compressible surface ensures a tight seal at the carburetor flange
• Direct replacement with no trimming required
• Holds up to vibration and constant engine heat cycles

Fits These Machines

• for Polaris SL 750 (1993-1995)

On-The-Job Use

• Carburetor removal and reinstallation on SL 750 watercraft
• Flame arrestor service and cleaning
• Intake sealing during engine tune-ups
• Restoring a proper air-fuel seal after intake work

Specs At A Glance

Good To Know

Q: Does this gasket need sealant? A: A clean, flat mating surface is usually enough, though some installers add a light gasket dressing. Follow the service manual for your model.

Q: Can a worn flame arrestor gasket affect performance? A: A leaking gasket can draw unmetered air into the carburetor, causing a lean condition. Replacing it restores the intended seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.