5830043 Carburetor Gasket for Polaris Virage 1050 2002

Carburetor Gasket for Polaris

This carburetor gasket is a replacement sealing component that fits between carburetor mounting surfaces on Polaris Virage 1050 watercraft, cross-referencing OEM part number 5830043.

Overview

This carburetor gasket for Polaris is a sealing component designed to sit between the carburetor and its mounting surface, preventing air and fuel leaks at the joint. A fresh carburetor gasket for Polaris helps restore a proper seal on older personal watercraft where the original gasket has hardened or degraded. It suits riders servicing the fuel system on a Polaris Virage 1050 who want a direct-fit replacement rather than a universal trim-to-size sheet.

Built For Performance

• Cross-references OEM part number 5830043 for straightforward matching
• Seals the carburetor mounting joint to help prevent vacuum and fuel leaks
• Cut to a specific profile for a clean fit on the mounting flange
• Constructed from gasket material suited to contact with fuel and engine heat
• Sold as a single replacement gasket for one mounting position

Fits These Machines

• for Polaris Virage 1050, 2002

On-The-Job Use

• Carburetor rebuilds and fuel system servicing
• Resealing a leaking carburetor base on a Virage 1050
• Routine maintenance before seasonal riding
• Replacing a hardened or torn gasket during tear-down

Specs At A Glance

Good To Know

Q: Do I need to replace this gasket every time I remove the carburetor? A: Yes, a gasket that has been compressed and exposed to fuel is best replaced each time the carburetor is pulled to avoid leaks. Q: Can I reuse the old gasket if it still looks intact? A: Reusing an old gasket risks a poor seal and lean running, so fitting a new one is the safer choice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.