5830062 Flame Arrestor Gasket for Polaris SLH 700 1998-2001

Flame Arrestor Gasket for Polaris SLH 700

This flame arrestor gasket is a direct-fit replacement seal that mounts between the flame arrestor and the engine intake on 1998-2001 Polaris SLH 700 watercraft, and it is built to the 5830062 reference number.

Overview

This flame arrestor gasket for Polaris SLH 700 keeps a tight seal between the flame arrestor housing and the intake so air flows as the engine was designed. The flame arrestor gasket prevents unmetered air from slipping past the mounting surface, which helps the engine run clean at idle and throughout the throttle range. It is a practical replacement for riders servicing older personal watercraft that have been sitting or are due for a tune-up.

Built For Performance

• Precision-cut to match the flame arrestor mounting flange
• Seals the intake path to prevent vacuum leaks
• Heat-resistant material suited to engine compartment temperatures
• Direct replacement for reference number 5830062
• Easy bolt-on install with basic hand tools

Fits These Machines

• for Polaris SLH 700, 1998-2001

On-The-Job Use

• Routine intake and carburetor service
• Top-end rebuilds and gasket replacement jobs
• Restoring a stored or non-running watercraft
• Seasonal maintenance before hitting the water

Specs At A Glance

Good To Know

Q: Do I need to replace the gasket every time the flame arrestor is removed? A: Yes, a fresh flame arrestor gasket is recommended each time the housing is taken off to keep the seal reliable. Reusing a compressed gasket can allow air leaks that affect how the engine runs.

Q: Can this gasket be reused? A: This flame arrestor gasket is intended as a single-use sealing part. Once it has been torqued down, replacing it is the safest way to maintain an airtight fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.