Skip to product information
1 of 1

5D3-83922-01-00 Right Brake Lever for Yamaha YFZ450R 2009-2026 YFZ 450R

5D3-83922-01-00 Right Brake Lever for Yamaha YFZ450R 2009-2026 YFZ 450R

Regular price $41.79
Regular price Sale price $41.79
Sale Sold out
Quantity

Right Brake Lever for Yamaha YFZ450R

This right brake lever is a direct replacement front brake lever for the Yamaha YFZ450R, built to OEM cross-reference 5D3-83922-01-00, and restores the firm, predictable braking response riders rely on.

Overview

This right brake lever is a replacement front brake lever made for the Yamaha YFZ450R from 2009 through 2026. It swaps in for the factory lever cross-referenced to 5D3-83922-01-00, helping riders get back to sharp front brake control quickly. A dependable right brake lever for Yamaha YFZ450R owners who want a clean fit at a sensible price.

Built For Performance

  • Direct cross-reference to OEM part number 5D3-83922-01-00 for straightforward replacement
  • Built as a front right brake lever for the YFZ450R hydraulic brake system
  • Shaped to mirror the original lever profile for consistent reach and pull
  • Resistant finish that stands up to dirt, mud, and repeated lever action
  • Intended for Yamaha YFZ450R models spanning 2009 through 2026

Fits These Machines

  • for Yamaha YFZ450R 2009
  • for Yamaha YFZ450R 2010
  • for Yamaha YFZ450R 2011
  • for Yamaha YFZ450R 2012
  • for Yamaha YFZ 450R across later model years through 2026

On-The-Job Use

  • Motocross and closed-course racing where brake control is critical
  • Trail and dune riding with frequent front brake modulation
  • Replacing a bent or snapped lever after a tip-over
  • Seasonal brake system maintenance and refresh

Specs At A Glance

Part Number(s) 5D3-83922-01-00
Position Front Right
Type Brake Lever
Compatibility for Yamaha YFZ450R 2009-2026

Good To Know

Q: Is this lever a left and right set? A: No, it is a single right-side front brake lever meant to replace the stock lever on the listed Yamaha YFZ450R models.

Q: Do I need to drain the brake fluid to install it? A: A lever replacement normally does not require draining fluid, but check lever firmness afterward and bleed the system if it feels spongy.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details