5x Rear Steering Knuckle Bushing for Tesla Model 3 2017-2023 Model Y 2020-2024

Rear Steering Knuckle Bushing for Tesla

This rear steering knuckle bushing set is a suspension wear component that mounts at the rear knuckle to control play, and it is supplied as a five piece set for Tesla Model 3 2017-2023 and Model Y 2020-2024 applications.

Overview

These rear steering knuckle bushings replace worn factory bushings that allow excess movement at the rear knuckle. The steering knuckle bushing set is supplied as five pieces so a full rear corner service can be completed in one job. It suits Tesla Model 3 and Model Y owners addressing clunks, vagueness, or uneven rear tire wear tied to worn bushings.

Built For Performance

• Five piece set covers a full rear knuckle bushing service
• Dampens rear knuckle movement to tighten suspension response
• Designed to match factory bushing dimensions for direct replacement
• Rubber construction absorbs road vibration at the rear suspension
• Sold as a matched set for consistent behavior side to side

Fits These Machines

• for Tesla Model 3 2017-2023
• for Tesla Model Y 2020-2024

On-The-Job Use

• Replacing collapsed or cracked rear knuckle bushings
• Rear suspension refresh on higher mileage Model 3 and Model Y vehicles
• Addressing rear end clunks and looseness over bumps
• Supporting a wheel alignment after rear suspension work

Specs At A Glance

Good To Know

Q: Is a press required to install these bushings? A: These are press fit bushings, so a hydraulic press or a proper bushing driver set is normally needed. Professional installation is recommended.

Q: Should an alignment follow installation? A: Yes, an alignment after rear bushing replacement helps restore correct rear suspension geometry. Plan it as part of the same service.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.