Skip to product information
1 of 1

6" Carbides for Arctic Cat Crossfire 1000 2007-2008 Pair

6" Carbides for Arctic Cat Crossfire 1000 2007-2008 Pair

Regular price $197.99
Regular price Sale price $197.99
Sale Sold out
Quantity

6" Carbides for Arctic Cat Crossfire 1000

These 6 inch carbides are a pair of snowmobile ski wear bars with carbide runners that bolt under the skis to give the Crossfire 1000 a sharper bite on hardpack and ice. The Sno-Pro profile pairs with your factory skis for direct bolt-on replacement, and each carbide in this 2 pack is built to restore steering control lost to worn stock runners.

Overview

These 6" Carbides for Arctic Cat Crossfire 1000 are a pair of replacement ski runners with hard carbide inserts, made for riders who want sharper steering response on hardpack and icy trails. The Sno-Pro style carbides bolt onto the stock ski saddles so the Crossfire 1000 tracks straight through corners instead of washing out. Sold as a matched pair so both skis get the same fresh bite in one install.

Built For Performance

  • 6 inch carbide runner length tuned for trail and cross country riding
  • Sno-Pro profile for aggressive cornering bite on hard surfaces
  • Hardened carbide inserts resist wear and hold an edge season after season
  • Sold as a pair so both skis are refreshed at the same time
  • Direct bolt-on fit for the factory ski saddle on the listed model
  • Steel host bar with welded carbide segments for a solid, stable runner

Fits These Machines

  • for Arctic Cat Crossfire 1000, 2007-2008

On-The-Job Use

  • Trail riding on hardpack and groomed corridors
  • Ice and low-snow conditions where steering bite matters most
  • Cross country riding that mixes firm trail with soft snow
  • Replacing worn or dulled factory runners at the start of the season
  • Sharpening corner entry on the Crossfire 1000 chassis

Specs At A Glance

Part Type Ski Carbide Runner
Carbide Length 6 in
Quantity Pair (2 carbides)
Style Sno-Pro

Good To Know

Q: Do I need to remove the skis to install these carbides? A: No, these carbides bolt to the ski saddle from underneath, so you can usually swap them with the skis still on the sled. Fresh hardware and a torque check on the mounting bolts are recommended.

Q: How often should ski carbides be replaced? A: Carbide runners wear down with every mile on hardpack and pavement, so inspect the inserts at the start of each season. Once the carbide is worn flush or steering feels vague, it is time for a new pair.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details