601-082 Wireless Ignition Module Switch w/ Key Fob Fit 11-14 Chrysler Dodge Jeep
601-082 Wireless Ignition Module Switch w/ Key Fob Fit 11-14 Chrysler Dodge Jeep
FREE, Fast Shipping on all orders!
Wireless Ignition Module Switch for Chrysler Dodge Jeep
The 601-082 wireless ignition module switch with key fob replaces the push-button start module on select 2011-2014 Chrysler, Dodge, and Jeep vehicles, restoring keyless ignition and remote key fob functions.
Overview
This wireless ignition module switch with key fob is a direct replacement for the factory wireless ignition node (WIN) found in many 2011-2014 Chrysler, Dodge, and Jeep models. The assembly includes a matched key fob transmitter, allowing the vehicle to recognize the fob and start with the push of a button once the module is programmed. It's an essential repair part for technicians and owners addressing a no-start condition, intermittent key detection, or failed ignition module.
Built For Performance
- Includes a new wireless ignition module switch and a pre-paired key fob for streamlined replacement
- Engineered to meet or exceed OE transmission range and signal stability
- Sealed housing protects internal electronics from dust and moisture
- Tested for consistent push-to-start and accessory mode activation
- Plug-and-play connector matches factory harness with no wire splicing
- Designed to support vehicle immobilizer and security functions post-programming
Fits These Machines
- for Chrysler 200 2011-2014
- for Chrysler 300 2011-2014
- for Dodge Avenger 2011-2014
- for Dodge Charger 2011-2014
- for Dodge Challenger 2011-2014
- for Dodge Journey 2011-2014
- for Jeep Grand Cherokee 2011-2014
- for Jeep Compass 2011-2014
On-The-Job Use
- Restoring push-button start after an original WIN module failure
- Replacing a lost or damaged key fob alongside a faulty ignition module
- Solving intermittent "Key Not Detected" messages on the instrument cluster
- Used by auto repair shops to complete a WIN module replacement and reprogramming service
- Frequent repair on high-mileage Chrysler, Dodge, and Jeep vehicles with push-to-start
Specs At A Glance
| Part Number(s) | 601-082 |
| Module Type | Wireless Ignition Node (WIN) |
| Key Fob Included | Yes, 1 key fob with integrated transponder |
| Frequency | 315 MHz (typical for North America) |
| Connector Type | Vehicle-specific multi-pin plug |
| Programming Required | Yes, module must be programmed to vehicle |
Good To Know
Q: Will this module work without programming? A: No, the wireless ignition module switch must be programmed to the vehicle using a compatible scan tool; professional installation and programming are strongly recommended.
Q: Does the included key fob need to be cut? A: This kit includes the electronic module and fob transmitter; the emergency key insert is not included, so if your vehicle uses a key blade in the fob, you’ll need to transfer or cut a new key blade separately.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
