62T-13566-00-00 Reed Valve Gasket for Yamaha Wave Blaster 700 1996

Reed Valve Gasket for Yamaha Wave Blaster 700

This reed valve gasket, OEM cross-reference 62T-13566-00-00, seals the reed valve assembly on Yamaha Wave Blaster 700 personal watercraft for 1996, keeping the intake path airtight and the engine drawing a clean air-fuel mix.

Overview

This reed valve gasket is a direct-fit sealing component for the Yamaha Wave Blaster 700, positioned between the reed valve cage and the intake manifold. It stops air leaks that sap power and cause rough running. It is made for riders and mechanics servicing 1996 Wave Blaster 700 machines who need a trustworthy replacement reed valve gasket for intake work.

Built For Performance

• Precision-cut to match the reed valve flange for a tight seal
• Made from fuel-resistant gasket material
• OEM cross-reference 62T-13566-00-00 for direct fitment
• Handles the heat and vibration of marine two-stroke use
• Seals the intake path to protect air-fuel mixture integrity

Fits These Machines

• for Yamaha Wave Blaster 700, 1996

On-The-Job Use

• Reed valve service and intake rebuilds
• Top-end engine maintenance on personal watercraft
• Seasonal tune-ups before hitting the water
• Restoring proper sealing after reed cage removal

Specs At A Glance

Good To Know

Q: How often should a reed valve gasket be replaced? A: Replace it whenever the reed valve assembly is removed or if you notice intake leaks, rough idling, or power loss on your Wave Blaster 700.

Q: Does this gasket require sealant during installation? A: Most installations do not require sealant, but always follow your service manual and inspect the mating surfaces for flatness before torquing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.