64X-11181-00-00 Head Gasket for Yamaha Wave Raider 760 1996

Head Gasket for Yamaha Wave Raider 760

This head gasket (OEM cross-reference 64X-11181-00-00) seals the cylinder head to the engine block on the Yamaha Wave Raider 760, keeping compression contained and coolant where it belongs.

Overview

This head gasket for Yamaha Wave Raider 760 is a direct-fit sealing component for the 1996 model. It replaces the factory gasket referenced as 64X-11181-00-00, restoring a tight seal between the cylinder head and engine block. Built for riders and mechanics handling top-end service on the Wave Raider 760.

Built For Performance

• Precision-cut to match the cylinder head and block mating surfaces
• Seals combustion chambers to maintain proper compression
• Withstands the heat cycling typical of two-stroke marine engines
• Reinforced construction resists blowout under load
• Direct replacement for OEM reference 64X-11181-00-00

Fits These Machines

• for Yamaha Wave Raider 760 (1996)

On-The-Job Use

• Top-end rebuilds after overheating or gasket failure
• Routine engine refresh during off-season maintenance
• Cylinder head removal and reinstallation service
• Compression loss diagnostics and repair

Specs At A Glance

Good To Know

Q: Does this gasket require any sealant during installation? A: Most head gaskets of this type install dry unless the service manual specifies otherwise, so check your Yamaha manual before adding anything.

Q: Can I reuse this head gasket if I remove the cylinder head again? A: Head gaskets are designed for single-use, so replace it any time the cylinder head is removed to keep a reliable seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.