66V-11193-00-00 Head Cover Gasket for Yamaha XL 1200 2001

Head Cover Gasket for Yamaha

The head cover gasket for Yamaha seals the cylinder head cover to the head on the 66V-11193-00-00 application, keeping oil contained and dirt out of the top end of the engine.

Overview

This head cover gasket is a direct-fit sealing component for the Yamaha XL 1200 and other applications that use the 66V-11193-00-00 number. The head cover gasket holds a clean seal between the valve cover and cylinder head, preventing oil seepage and keeping crankcase pressure where it belongs. It is made for riders and mechanics who want a dependable seal during a top-end service or rebuild.

Built For Performance

• Pre-formed to match the cylinder head cover mating surface for a clean seal
• Construction resists heat cycling and oil exposure in the top end
• Fits the 66V-11193-00-00 application without trimming or modification
• Designed to seal against oil weep at the head cover joint
• Compact, lightweight part that is easy to install during routine service

Fits These Machines

• for Yamaha XL 1200 (2001)

On-The-Job Use

• Top-end service and cylinder head cover resealing
• Engine rebuilds where the head cover is removed
• Routine maintenance to address oil seepage at the cover joint
• Shop and DIY repair work on Yamaha personal watercraft engines

Specs At A Glance

Good To Know

Q: Does this gasket require sealant? A: Many head cover gaskets install dry, but always check the service manual for the specific Yamaha application. A thin film of appropriate sealant is only used where specified.

Q: Can I reuse the old gasket? A: A gasket that has been compressed or heat-cycled should be replaced to avoid oil leaks. This gasket is intended for one-time installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.