689-41112-A0-00 Exhaust Gasket for Yamaha Wave Jammer 500 1987-1990

Exhaust Gasket for Yamaha Wave Jammer 500

This exhaust gasket fits for Yamaha Wave Jammer 500 models from 1987 through 1990 and seals the exhaust joint to prevent leaks, cross-referencing OEM part 689-41112-A0-00.

Overview

This exhaust gasket is made for the for Yamaha Wave Jammer 500 and seals the exhaust connection on 1987 to 1990 models. A fresh exhaust gasket stops hot gases and water from escaping at the joint, protecting nearby components from heat and corrosion. It is a direct replacement for riders and mechanics servicing this personal watercraft.

Built For Performance

• Direct replacement for OEM part 689-41112-A0-00
• Seals the exhaust joint to stop gas and water leaks
• Heat resistant material suited to exhaust temperatures
• Designed to fit 1987 to 1990 for Yamaha Wave Jammer 500 models
• Simple bolt-on installation at the exhaust connection

Fits These Machines

• for Yamaha Wave Jammer 500 (1987-1990)

On-The-Job Use

• Routine exhaust system maintenance
• Rebuilding a for Yamaha Wave Jammer 500 engine
• Replacing a blown or leaking exhaust gasket
• Seasonal service and tune-ups

Specs At A Glance

Good To Know

Q: How often should an exhaust gasket be replaced? A: Replace it any time the exhaust joint is opened or if you find signs of leakage, such as soot or water at the connection. Worn gaskets can cause performance and safety issues.

Q: Does this gasket require any sealant? A: A clean, dry mating surface is normally enough for a proper seal. Some installers add a thin bead of exhaust-rated sealant, but check your service manual first.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.