6B6-61315-01-94 Jet Pump Vane Stator for Yamaha AR 210 1100 2006-2015

Jet Pump Vane Stator for Yamaha

This jet pump vane stator is a replacement steering and thrust component for Yamaha personal watercraft and jet boats, cross-referencing OEM part number 6B6-61315-01-94, and it bolts into the pump housing to straighten water flow leaving the impeller.

Overview

The jet pump vane stator for Yamaha sits directly behind the impeller and redirects the high-pressure water stream to produce forward thrust and responsive steering. Built as a direct-fit replacement, this jet pump vane stator restores the rear section of the pump assembly on 1100-series Yamaha jet boats. It suits owners repairing a damaged stator or refreshing a worn pump during routine service.

Built For Performance

• Cast and machined to match the 6B6-61315-01-94 stator profile
• Straightening vanes aligned to the impeller exit for efficient thrust conversion
• Corrosion-resistant surface finish for repeated freshwater and saltwater use
• Bolt-on mounting that reuses the factory pump housing fasteners
• Designed to seal against the wear ring and pump housing bore
• Weighs and balances comparably to the original stator it replaces

Fits These Machines

• for Yamaha AR 210 with 1100 engine, 2006-2015
• for Yamaha jet boats running the 1100-series pump assembly, 2006-2015

On-The-Job Use

• Replacing a cracked or corroded stator during pump rebuilds
• Restoring steering response after impact damage to the pump nozzle area
• Routine jet pump service on 1100-powered Yamaha boats
• Seasonal maintenance before launching for the summer

Specs At A Glance

Good To Know

Q: Does this stator fit both the 1100 and 1050 Yamaha pumps? A: This listing covers the 1100-series application for 2006-2015 AR 210 models. Check your pump serial and engine displacement before ordering to confirm the match.

Q: Can I install this without removing the whole pump assembly? A: On most Yamaha jet boats the pump must be unbolted from the transom to access the stator bolts. Plan for a full pump removal and reseal during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.