6B6-61315-01-94 Jet Pump Vane Stator for Yamaha FX Cruiser 1000 2003-2008

Jet Pump Vane Stator for Yamaha

The Jet Pump Vane Stator for Yamaha FX Cruiser 1000 (2003-2008) straightens water flow leaving the impeller to keep thrust steady, and it cross-references OEM part number 6B6-61315-01-94.

Overview

This Jet Pump Vane Stator for Yamaha is the fixed vane section of the jet pump that converts the impeller's swirling output into a straight, efficient jet. It suits owners servicing a Yamaha FX Cruiser 1000, and the 6B6-61315-01-94 cross-reference helps confirm the correct replacement.

Built For Performance

• Vane geometry guides impeller outflow for efficient thrust
• Machined housing surfaces support a stable fit in the pump
• Direct replacement for the stock stator on the 6B6 pump
• Cross-references OEM part number 6B6-61315-01-94
• Built to handle the loads of regular PWC operation
• Finishing supports clean mating with the surrounding pump parts

Fits These Machines

• for Yamaha FX Cruiser 1000, 2003-2008

On-The-Job Use

• Jet pump service after impeller or bearing replacement
• Bringing a used FX Cruiser 1000 pump back to stock spec
• Swapping out a cracked or pitted stator
• Routine maintenance on skis used in fresh or salt water

Specs At A Glance

Good To Know

Q: Is this the right stator for my FX Cruiser 1000? A: It is listed for the 2003-2008 FX Cruiser 1000 and matches OEM number 6B6-61315-01-94. Check your pump before ordering to be sure.

Q: Can I install this without pulling the whole pump? A: Stator replacement is normally done with the pump removed from the hull, which also makes inspection of the impeller and wear ring easier. Follow your service manual for torque values.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.