6B6-61315-01-94 Jet Pump Vane Stator for Yamaha SR 230 1000 2003-2005

Jet Pump Vane Stator for Yamaha

This jet pump vane stator for Yamaha replaces OEM part 6B6-61315-01-94, guiding water flow out of the pump for stable thrust.

Overview

This jet pump vane stator for Yamaha is a direct-fit replacement for the pump vanes that straighten water flow after the impeller. The stator restores the smooth thrust and pressure recovery that the pump needs for consistent performance on the water. It suits riders replacing a bent, pitted, or corroded stator on a Yamaha personal watercraft.

Built For Performance

• Rugged cast construction for marine use
• Vane geometry matched to the OEM 6B6-61315-01-94 design
• Straightens impeller discharge flow to recover thrust
• Resists corrosion from continuous water exposure
• Direct bolt-in fitment to the matching pump housing

Fits These Machines

• for Yamaha SR 230 1000 (2003-2005)
• for Yamaha GP-R 800 (2003-2005)

On-The-Job Use

• Replacing a bent or pitted stator after ingesting debris
• Restoring pump performance during a rebuild
• Routine driveline service on Yamaha personal watercraft
• Keeping thrust consistent across the rev range

Specs At A Glance

Good To Know

Q: How do I know if my stator needs replacement? A: Bent vanes, deep pitting, or cracks in the casting are signs it is time for a new stator, and handling or top speed often drops noticeably before visible damage appears.

Q: Does this stator include the wear ring or impeller? A: No, it is the vane stator only, so reuse your existing impeller and wear ring unless they are also worn and due for replacement.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.