6B6-61315-01-94 Jet Pump Vane Stator for Yamaha XL 800 2000-2001

Jet Pump Vane Stator for Yamaha XL 800

This jet pump vane stator for Yamaha XL 800 personal watercraft from 2000 to 2001 (OEM 6B6-61315-01-94) straightens and directs water flow exiting the impeller to restore thrust and handling.

Overview

The Jet Pump Vane Stator for Yamaha XL 800 is a replacement pump component that sits behind the impeller and converts swirling discharge into a straight, efficient stream. It fits 2000 to 2001 XL 800 models and cross-references OEM 6B6-61315-01-94. This stator suits riders replacing a bent, cracked, or corroded vane section to bring pump performance back to spec.

Built For Performance

• Cast vane geometry designed to straighten impeller discharge flow
• Direct cross-reference to OEM 6B6-61315-01-94
• Bolts into the stock jet pump housing without adapter parts
• Rigid construction resists flex under pump load
• Corrosion-resistant finish suited to regular water exposure
• Restores lost thrust caused by a damaged original stator

Fits These Machines

• for Yamaha XL 800 (2000)
• for Yamaha XL 800 (2001)

On-The-Job Use

• Replacing a bent or cracked stator after impact with debris
• Refreshing pump efficiency during seasonal maintenance
• Restoring acceleration and top speed on the water
• Repairing a pump pulled for impeller or wear ring service

Specs At A Glance

Good To Know

Q: Will this stator fit my 2000 Yamaha XL 800? A: Yes, this stator is listed for 2000 to 2001 XL 800 models and cross-references OEM 6B6-61315-01-94. Confirm your pump assembly and serial number before ordering.

Q: Can I install this without removing the whole pump? A: Stator replacement usually requires pulling the pump assembly to access the vane section properly. Have a new gasket or sealant on hand for reassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.