6B6-61315-01-94 Jet Pump Vane Stator for Yamaha XLT 1200 2002-2005

Jet Pump Vane Stator for Yamaha

This jet pump vane stator is a replacement stator component for Yamaha personal watercraft, cross-referencing OEM part number 6B6-61315-01-94, designed to straighten and guide water flow through the pump for consistent thrust.

Overview

This jet pump vane stator serves as the stationary guide section of the pump assembly on Yamaha 1200-series wave runners. It channels water leaving the impeller to reduce turbulence and support steady propulsion. It is intended for riders replacing a bent, corroded, or worn stator on compatible models.

Built For Performance

• Stator vane design straightens water flow exiting the impeller
• Cast construction suited to the marine pump environment
• Cross-references OEM part number 6B6-61315-01-94
• Bolt-on replacement for the original stator location
• Helps restore pump efficiency after vane damage

Fits These Machines

• for Yamaha XLT 1200, 2002-2005

On-The-Job Use

• Pump rebuilds after impeller or wear ring replacement
• Repairing damage from debris drawn through the jet pump
• Restoring factory water flow characteristics on the XLT 1200
• Routine driveline service on personal watercraft

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: No, this is an aftermarket replacement stator that cross-references OEM number 6B6-61315-01-94. It is not manufactured or branded by Yamaha.

Q: Should the stator be replaced with the impeller? A: Inspect the vanes for bends or erosion whenever the impeller and wear ring are serviced, since a damaged stator can reduce pump efficiency. Replace it if the vanes show distortion.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.