6EX-45514-00-00 Impeller Shaft for Yamaha V1 1100 2015

Impeller Shaft for Yamaha V1 1100

This impeller shaft, OEM cross-reference 6EX-45514-00-00, is the driveshaft component that transfers engine power to the jet pump impeller in 2015 Yamaha V1 1100 personal watercraft.

Overview

This impeller shaft is a replacement driveline component made for the 2015 Yamaha V1 1100, OEM cross-reference 6EX-45514-00-00. It carries torque from the engine coupler back to the jet pump, where the impeller converts that rotation into thrust. Watercraft owners and mechanics rebuilding or servicing the pump section of a V1 1100 will find this impeller shaft built to spec for that machine.

Built For Performance

• Direct cross-reference to OEM part number 6EX-45514-00-00 for a confident match
• Machined splines sized for the factory engine coupler and impeller hub
• Constructed from corrosion-resistant material suited to constant water exposure
• Straight, balanced shaft geometry to keep pump vibration low
• Fits 2015 Yamaha V1 1100 jet pump driveline

Fits These Machines

• for Yamaha V1 1100, 2015

On-The-Job Use

• Rebuilding the jet pump assembly after bearing or seal wear
• Restoring driveline power transfer after a damaged or corroded shaft
• Routine pump service on a 2015 V1 1100
• Replacing a bent shaft after debris is pulled through the pump

Specs At A Glance

Good To Know

Q: Does this replace the original part on a 2015 V1 1100? A: Yes, it cross-references OEM number 6EX-45514-00-00 and is intended for a direct swap on that machine. Always verify your serial number and pump assembly before ordering.

Q: What should I check when installing a new impeller shaft? A: Inspect the pump bearings, seals, and coupler for wear at the same time, since those parts often fail together with the shaft. Replacing them alongside the shaft helps avoid repeat teardown.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.