6EY-11181-01-00 Head Gasket for Yamaha V1 1050 2016 PWC

Head Gasket for Yamaha V1 1050

This head gasket seals the cylinder head to the engine block on the for Yamaha V1 1050, cross-referenced to OEM part number 6EY-11181-01-00, keeping compression contained and coolant where it belongs.

Overview

This head gasket is a direct-fit sealing component made for the for Yamaha V1 1050. It seals the mating surface between the cylinder head and block to prevent compression loss and fluid leaks. It suits riders and mechanics performing top-end rebuilds or replacing a blown gasket.

Built For Performance

• Precision-cut to match OEM port and bolt-hole locations
• Withstands high combustion temperatures and pressure
• Seals coolant and oil passages against leakage
• Maintains proper compression for consistent power output
• Direct replacement for OEM part 6EY-11181-01-00

Fits These Machines

• for Yamaha V1 1050 (2016)

On-The-Job Use

• Top-end rebuilds after overheating or gasket failure
• Routine engine refresh during a piston or valve job
• Restoring compression on a high-hour engine

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: This is an aftermarket head gasket built to match OEM part 6EY-11181-01-00 for the V1 1050, not an original brand product.

Q: Should head bolts be replaced at the same time? A: Many manufacturers recommend new head bolts on engines that use torque-to-yield fasteners, so check your service manual before reinstalling.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.