6EY-81940-09-00 Starter Solenoid for Yamaha Jet Blaster 1050 2022-2026

Starter Solenoid for Yamaha Jet Blaster 1050

This starter solenoid for Yamaha personal watercraft provides dependable high-current switching to crank the engine on Jet Blaster 1050 models, and it cross-references OEM number 6EY-81940-09-00.

Overview

This starter solenoid is a direct-fit electrical component built to engage the starter motor on the Jet Blaster 1050. It carries the heavy current between the battery and the starter so the engine turns over reliably every time the start button is pressed. Riders and mechanics replacing a failed or clicking solenoid will find this a clean swap for the original unit.

Built For Performance

• Cross-references OEM part number 6EY-81940-09-00
• Heavy-duty contacts made to handle repeated high-current starting loads
• Sealed housing resists moisture and spray common in marine engine bays
• Direct bolt-in fit for the stock solenoid location
• Spade and ring terminal connections match factory wiring
• Compact body sized for the Jet Blaster electrical box

Fits These Machines

• for Yamaha Jet Blaster 1050, 2022-2026

On-The-Job Use

• Replacing a solenoid that clicks but will not turn the engine over
• Restoring consistent starting on the water after a no-crank fault
• Routine electrical maintenance on the Jet Blaster 1050
• Keeping a spare solenoid on hand for the riding season

Specs At A Glance

Good To Know

Q: How do I know the solenoid is the problem? A: A single loud click from the electrical box with no crank usually points to the solenoid, though a weak battery can mimic the same symptom. Test battery voltage first, then check for voltage at the starter side of the solenoid.

Q: Do I need to replace anything else at the same time? A: Inspect the starter relay wiring and battery cables for corrosion while the solenoid is out, since poor connections can shorten the life of the new part. Cleaning and tightening terminals before installation is a sound practice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.