6GA-44517-00-00 Motor Mount for Yamaha GP 800 2001-2002 PWC

Motor Mount for Yamaha

This motor mount replaces a worn or cracked factory mount on Yamaha GP 800 watercraft, and it carries the OEM cross-reference 6GA-44517-00-00.

Overview

The motor mount for Yamaha secures the engine to the hull so driveline alignment stays consistent under throttle. It fits Yamaha GP 800 models from 2001 and 2002 and cross references 6GA-44517-00-00. Riders and shops install a mount for Yamaha when the original shows cracks, sag, or excessive vibration.

Built For Performance

• Cross-references OEM part number 6GA-44517-00-00 for direct replacement fit
• Bonded rubber body damps engine vibration before it transfers to the hull
• Steel base plate with pre-drilled holes for a bolt-on install
• Rated to hold engine torque through sustained on-water use
• Stands up to fuel, oil, and bilge water exposure

Fits These Machines

• for Yamaha GP 800, 2001-2002

On-The-Job Use

• Replacing a collapsed or torn factory motor mount during engine service
• Restoring driveline alignment after engine or hull repairs
• Reducing vibration felt through the hull and bars at speed
• Routine upkeep on older GP 800 watercraft

Specs At A Glance

Good To Know

Q: How do I know a mount needs replacing? A: Look for cracked or separated rubber, a sagging engine, or vibration that gets worse at speed; any of these points to a mount that has failed.

Q: Should mounts be replaced as a set? A: Replacing all mounts at once keeps engine alignment even and avoids chasing vibration from the next worn mount.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.