6GA-44517-00-00 Motor Mount for Yamaha VX-C 1050 2019-2026

Motor Mount for Yamaha VX-C 1050

This motor mount for Yamaha personal watercraft secures the engine to the hull on VX-C 1050 models, referencing OEM part 6GA-44517-00-00.

Overview

This motor mount for Yamaha is a replacement engine mounting component that holds the powerplant firmly in place while absorbing vibration. Built to the dimensions of OEM part 6GA-44517-00-00, it keeps the engine aligned so the drive line runs true. It suits riders and shops servicing VX-C 1050 watercraft from 2019 through 2026.

Built For Performance

• Durable construction engineered to resist corrosion in marine environments
• Bonded rubber element dampens engine vibration at the mounting point
• Factory-matched bolt pattern for direct replacement fit
• Holds engine alignment to protect the coupler and driveshaft
• Rated for the load and motion of a 1050cc marine engine

Fits These Machines

• for Yamaha VX-C 1050, 2019-2026

On-The-Job Use

• Replacing a worn or collapsed factory mount during engine service
• Routine driveline maintenance on VX-C 1050 hulls
• Shop repairs after vibration or alignment complaints
• Refreshing mounts during engine removal or rebuild work

Specs At A Glance

Good To Know

Q: How many mounts does a typical replacement job need? A: Most engines use several mounts, so check all positions and replace any that are cracked, soft, or collapsed. Ordering the quantity you need at once avoids a second round of labor.

Q: Does this mount need to be torqued to a specific spec? A: Yes, engine mounts should be tightened to the torque figure listed for your model in the service manual. Following the manual sequence keeps the engine aligned and prevents premature mount failure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.