6JC-11181-00-00 Head Gasket for Yamaha SX 192 1800 2013-2016

Head Gasket for Yamaha SX 192 1800

This head gasket for Yamaha SX 192 1800 watercraft seals the cylinder head to the engine block and carries the OEM cross-reference 6JC-11181-00-00.

Overview

This head gasket for Yamaha SX 192 1800 fits 2013 through 2016 models and provides the critical seal between the cylinder head and engine block. Built to hold compression and keep coolant and oil in their proper passages, this head gasket for Yamaha keeps your engine running the way it should.

Built For Performance

• Multi-layer construction designed to hold compression under load
• Precision-cut openings matched to the cylinder bore and coolant passages
• Heat-resistant material suited to marine engine operating temperatures
• Direct replacement for OEM part number 6JC-11181-00-00
• Seals combustion pressure, coolant, and oil paths at the head-to-block joint

Fits These Machines

• for Yamaha SX 192 1800, 2013-2016

On-The-Job Use

• Top-end rebuilds after overheating or compression loss
• Cylinder head removal and reinstallation jobs
• Routine engine refresh on high-hour watercraft

Specs At A Glance

Good To Know

Q: Should head bolts be replaced at the same time? A: Many torque-to-yield head bolts are single-use, so check your service manual and replace them if specified for this engine.

Q: Is sealant required with this gasket? A: Follow the factory service procedure for your Yamaha 1800 engine, since most head gaskets of this type install dry.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.