6K8-41114-A1-00 Exhaust Cover Gasket for Yamaha Wave Runner 500

Exhaust Cover Gasket for Yamaha Wave Runner 500

This exhaust cover gasket seals the exhaust cover on Yamaha Wave Runner 500 watercraft, matching OEM cross-reference 6K8-41114-A1-00.

Overview

This exhaust cover gasket is a direct-fit sealing component for the Yamaha Wave Runner 500 personal watercraft produced from 1989 through 1993. The gasket installs between the exhaust cover and the engine block, holding a tight seal that keeps exhaust gas and water from escaping at the joint. It is intended for owners and technicians servicing the exhaust side of a Wave Runner 500.

Built For Performance

• Cut to match the OEM 6K8-41114-A1-00 profile
• Heat-resistant material for exhaust-side service
• Seals the exhaust cover mating surface against gas and water leaks
• Compressible design for even sealing across the flange
• Single-piece gasket for simple installation

Fits These Machines

• for Yamaha Wave Runner 500 (1989-1993)

On-The-Job Use

• Exhaust cover resealing during engine service
• Exhaust and cooling leak repair
• Routine gasket replacement on older watercraft
• Top-end rebuilds and off-season maintenance

Specs At A Glance

Good To Know

Q: Should this gasket be replaced whenever the exhaust cover comes off? A: Yes, gaskets are meant for single use, so replace it any time the cover is removed to avoid leaks. An old gasket can allow exhaust gas or water to escape at the joint.

Q: Does this listing include more than one gasket? A: This listing covers one exhaust cover gasket. Review your parts diagram if your repair calls for additional gaskets or seals at the same time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.