6M6-13556-A1-00 Carburetor Gasket for Yamaha SuperJet 650 1990-1993

Carburetor Gasket for Yamaha

This carburetor gasket is a direct-fit sealing component that prevents air and fuel leaks at the carburetor mounting surface, and it carries the OEM cross-reference 6M6-13556-A1-00.

Overview

This carburetor gasket seals the mating surface where the carburetor mounts on Yamaha SuperJet 650 watercraft. A fresh carburetor gasket restores a proper air-tight seal, which keeps air-fuel mixture consistent and idle quality stable. This gasket is built for riders performing routine carburetor service on their 1990 to 1993 SuperJet 650.

Built For Performance

• Precision-cut to match the OEM 6M6-13556-A1-00 mounting footprint
• Fuel and oil resistant material stands up to constant gasoline exposure
• Compressible construction seals minor surface imperfections on the mounting flange
• Heat tolerant for the operating temperatures of a running two-stroke engine
• Direct replacement for worn or hardened OEM gaskets

Fits These Machines

• for Yamaha SuperJet 650 (1990-1993)

On-The-Job Use

• Carburetor rebuilds and cleaning service
• Intake leak repairs on the mounting flange
• Routine top-end maintenance on two-stroke personal watercraft
• Restoring consistent idle and throttle response after gasket failure

Specs At A Glance

Good To Know

Q: Do I need to replace this gasket every time I remove the carburetor? A: Yes, carburetor gaskets compress over time and are not designed to be reused once removed. Installing a new carburetor gasket each time helps prevent air leaks that can cause a lean condition.

Q: Will this gasket fit aftermarket carburetors? A: It is designed to match the OEM mounting pattern referenced by part number 6M6-13556-A1-00. Verify your carburetor flange dimensions if you are running a non-stock setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.