6R7-45332-02-9M Bearing Housing for Yamaha Wave Runner III 650

Bearing Housing for Yamaha Wave Runner III 650

This bearing housing is a replacement jet pump component that supports and aligns the driveshaft bearing assembly on Yamaha Wave Runner III 650 watercraft, cross-referencing OEM part number 6R7-45332-02-9M.

Overview

This bearing housing is a direct-fit replacement for the jet pump assembly on Yamaha Wave Runner III 650 watercraft, holding the driveshaft bearing in correct alignment so the impeller spins true under load. Built to match the original mounting points and bore dimensions, it restores a worn or corroded housing without modification. It suits riders and mechanics maintaining 1992, 1993, 1995 and 1996 Yamaha Wave Runner III 650 models.

Built For Performance

• Cross-references OEM part number 6R7-45332-02-9M for straightforward number matching
• Machined bearing bore keeps the driveshaft bearing seated and aligned
• Corrosion-resistant construction suited to continuous water exposure
• Direct bolt-on fitment using factory mounting locations
• Sealing surfaces finished to accept the original seals and O-rings

Fits These Machines

• for Yamaha Wave Runner III 650, 1992
• for Yamaha Wave Runner III 650, 1993
• for Yamaha Wave Runner III 650, 1995
• for Yamaha Wave Runner III 650, 1996

On-The-Job Use

• Jet pump rebuilds when the original bearing housing shows wear or pitting
• Driveshaft bearing replacement jobs that require a fresh housing bore
• Routine driveline servicing on Yamaha Wave Runner III 650 watercraft
• Corrosion repair after extended saltwater use

Specs At A Glance

Good To Know

Q: Does this bearing housing include the bearing and seals? A: It is the housing only, so reuse or replace the bearing and seals separately as needed. A: Confirm the shaft and bearing are within spec before assembly.

Q: How do I know this fits my watercraft? A: Match the OEM number 6R7-45332-02-9M and the listed Wave Runner III 650 model years before ordering. A: Serial number differences can affect fitment, so verify against your machine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.