6R7-51117-01-00 Impeller Housing Trim Seal for Yamaha Wave Blaster 700 1993-1996

Impeller Housing Trim Seal for Yamaha

This impeller housing trim seal for Yamaha is a replacement seal that fits around the pump housing on Wave Blaster 700 personal watercraft, and it cross-references OEM part number 6R7-51117-01-00.

Overview

This impeller housing trim seal for Yamaha seals the gap around the pump housing on Wave Blaster 700 models. It keeps the housing seated cleanly against the hull to limit water intrusion and vibration. It suits riders servicing a worn or missing trim seal on their PWC.

Built For Performance

• Direct cross-reference to OEM part 6R7-51117-01-00 for simplified ordering
• Flexible trim profile that conforms to the housing edge
• Formulated for continuous water and spray exposure
• Resists cracking and hardening from sun and salt
• Cushions the housing to reduce vibration transfer

Fits These Machines

• for Yamaha Wave Blaster 700, 1993-1996

On-The-Job Use

• Replacing a hardened or missing trim seal after pump service
• Resealing the housing during an impeller or wear ring change
• Refreshing seals on older Wave Blaster 700 watercraft
• Routine pump maintenance at the start of the riding season

Specs At A Glance

Good To Know

Q: Is this a genuine OEM seal? A: This is an aftermarket replacement that cross-references the OEM part number. It fits the listed machines when the OEM number matches your unit.

Q: Can I install this without removing the pump? A: Access varies by model, but the seal is typically fitted with the housing removed so it seats evenly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.