6R8-51312-03-94 Jet Pump Housing for Yamaha Wave Raider 760 1996

Jet Pump Housing for Yamaha Wave Raider 760

This jet pump housing for Yamaha fits the 1996 Wave Raider 760 and carries the 6R8-51312-03-94 reference number for direct replacement of the worn housing that channels water through your personal watercraft's propulsion system.

Overview

This jet pump housing for Yamaha is the cast component that bolts to the pump section and holds the impeller and wear ring assembly in alignment. It restores the sealed water path on the 1996 Wave Raider 760 so thrust stays consistent. Riders and mechanics rebuilding a worn pump will find this housing a direct-fit replacement.

Built For Performance

• Cast aluminum body resists corrosion in fresh and salt water
• Machined bore seats the wear ring for a tight impeller clearance
• Stamped 6R8-51312-03-94 identification for easy cross-reference
• Bolt pattern matches the stock pump shoe and stator mounts
• Sealing surfaces finished to prevent cavitation-inducing air leaks

Fits These Machines

• for Yamaha Wave Raider 760 (1996)

On-The-Job Use

• Replacing a cracked or corroded pump housing after a season of saltwater riding
• Rebuilding the jet pump on a 1996 Wave Raider 760
• Restoring proper impeller clearance after wear ring service

Specs At A Glance

Good To Know

Q: Will this fit my 1996 Wave Raider 760? A: It is listed for the 1996 Wave Raider 760 jet pump assembly. Confirm your pump serial and existing part number before ordering.

Q: Does it come with the wear ring installed? A: This listing covers the housing itself unless photos show otherwise. Reuse or replace the wear ring and seals as needed during the rebuild.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.